Inspect and clean the feeder drive rollers

WHAT YOU NEED 

Tools:Security Torx Key SetFlat Head ScrewdriverAir Gun

Safety Equipment:Standard Personal Protective EquipmentSafety Gloves

Other Equipment:Wire brush

ClosedInspection and cleaning

CAUTIONPINCH POINT: Wear safety gloves and rotate the rollers very slowly.

  1. Isolate the saw electrically.
  2. Remove both feeder transparent covers.

  3. Inspect the drive rollers for any signs of damage and make sure they run freely.

    Note: contact Vekta Automation if any roller needs to be replaced.

  4. Make sure the drive rollers are secure and there is no lateral movement.

  5. With a wire brush, remove any timber shavings and build-up caught in the drive roller knurls.

    Note: where the wire brush is not sufficient, a flat head screwdriver can be used.

  6. Carefully rotate the drive rollers and continue cleaning until all timber shavings and build-up are removed.
  7. Blow down the feeders around each drive roller.
  8. Refit both feeder transparent covers.

ClosedTesting

CAUTIONWhen using the manual mode, make sure that everything and everyone is clear of moving parts to prevent damage or injuries.

  1. Turn on the electrical isolation switch on the front of the saw.
  2. Release the E‑stop button on the operator console.
  3. Rehome the saw.
  4. Open Simple.
  5. Using the Manual Mode window, operate the drive rollers in both directions.